Ahmad Naeemah Bashara; Farhad Qaderi
Abstract
Due to the rapid population and economic growth, the demand for water has increased. In addition, the natural resources are limited and degrade because of several factors such as the climate change. These challenges lead to reduce the ability of providing water at the required quantity and quality. One ...
Read More
Due to the rapid population and economic growth, the demand for water has increased. In addition, the natural resources are limited and degrade because of several factors such as the climate change. These challenges lead to reduce the ability of providing water at the required quantity and quality. One of solutions to maintain the sustainability of water supply from different sources is reuse of wastewater. For this aim, it is crucial to optimize wastewater systems. This research paper aims to describe different modelling possibilities and optimization methods for various components of integrated urban wastewater systems. The main conclusion of this research paper is the lack of study of optimum design and operation of urban wastewater systems in a holistic method. Moreover, most of previous studies on integrated wastewater management have been conducted on combined sewer systems.
Amirhossein Khourshidi; Farhad Qaderi
Abstract
In the realm of industrial development, a variety of organic pollutants, including petroleum compounds, have emerged as persistent environmental concerns due to their non-degradable nature. To effectively address this issue, plasma technology has garnered significant attention as a promising approach ...
Read More
In the realm of industrial development, a variety of organic pollutants, including petroleum compounds, have emerged as persistent environmental concerns due to their non-degradable nature. To effectively address this issue, plasma technology has garnered significant attention as a promising approach for wastewater treatment, offering the capability to eliminate a wide spectrum of contaminants. This research capitalizes on Response surface methodology (RSM) to explore the independent and combined effects of key factors such as initial concentration, pH, applied voltage, and time on the degradation of a specific pollutant known as PNP, utilizing non-thermal discharge plasma technology. The outcomes of this investigation unveiled several noteworthy trends. Enhancing the initial pH, applied voltage, and reaction time while reducing the initial concentration exhibited a positive influence on the removal efficiency. Additionally, the study examined the interactions among these variables, revealing both antagonistic and synergistic effects. Specifically, antagonistic relationships were observed between initial concentration and initial pH, initial concentration and applied voltage, as well as applied voltage and time. On the other hand, a synergistic effect was noted between initial concentration and time. By employing an optimization approach, the optimal conditions for achieving PNP degradation were determined to be as follows: an initial concentration of 50 mg/L, pH of 9.7, applied voltage of 13.75 kV, and a reaction time of 8 min, resulting in an impressive removal efficiency of 96.503%. The findings of this study underscore the immense potential of non-thermal discharge plasma technology and the utilization of RSM in advancing the optimization of advanced oxidation processes for effective wastewater treatment.
Saba Abdolalian; Farhad Qaderi
Abstract
The use of ultrasound is one of the most studied methods in treatment of water and wastewater. This study was going to remove pollutants from the supernatant of excess sludge by using of ultrasound. Initial raw supernatant with COD equal to 1600 mg/L and phosphorous equal to 80 mg/L was exposed to ultrasound. ...
Read More
The use of ultrasound is one of the most studied methods in treatment of water and wastewater. This study was going to remove pollutants from the supernatant of excess sludge by using of ultrasound. Initial raw supernatant with COD equal to 1600 mg/L and phosphorous equal to 80 mg/L was exposed to ultrasound. The experimental design was used to determine the experiments with variables including time (1.5-9.5 h), ultrasonic power (40-360 w), and the volume of sample (20-180 mL). COD and phosphorous were the responses, those were investigated in this research. Based on the Response Surface Methodology (RSM), a model for COD and phosphorous removal was obtained with a 95 % confidence interval. The optimized removal of COD (97.39 %) and phosphorous (98.73 %) was observed. According to the results, ultrasonic waves is a good way to remove COD and phosphorus from sludge. This method can be used in wastewater treatment plants for treatment of supernatant of excess sludge.
